Designed as a drop-in replacement for damaged or defective XT60 connectors on the Creality Ender-3 and Ender-3 PRO 3D Printers.
These are genuine AMASS XT60H Bullet Connectors, pre-soldered with thicker 12 AWG insulated silicone wiring. They are measured to the same length as the original cables for a perfect fit during installation.
Made from high temperature nylon, the gold plated connectors can safely handle the current between the power supply and control board.
Please note, the wire ends are tinned during the manufacturing process. It is strongly advised to cut these off before use, exposing bare wire for the best connection.
- Genuine AMASS XT60H Bullet Connectors
- Gold Plated Copper Connectors Rated for 60A max current
- Snap-on Covers provide insulation and heatshrink free use
- 12 AWG Cable is thicker than stock (14 Gauge)
- Pre-Soldered wiring w/ optional crimp spade terminals
- Matches existing Ender-3 Cables - Male Side: 150mm Female Side: 300mm
- (1) XT60H 150mm 12 AWG cable (for power supply)
- (1) XT60H 300mm 12 AWG cable (for electronics board)
- (2) Yellow Spade Terminals