3D Printer Prusa i3 V2 Alloy Build Plate, Y Carriage, Bearings, 12V 200W Heater.
New Version 2 aluminum build plate design has new feature - 3 point level adjustment option (as well as conventional 4-pint level adjustment option). 3-point adjustment feature is available with included in the kit Y carriage with the middle hole. This kit has high-temp silicone rubber heater which is pre-wired with power wires and thermistor signal cable. Please see supplied drawings and pictures for assembly sequence and design details.
Manual level adjustment thumb nuts (as pictured with Y-carriage plate) are also available in our store.
Aluminum Build Plate Features:
Thick 3mm plate maintains flatness across whole area.
Scratch resistant anodized surface.
Hidden countersunk mounting screws.
Kit uses high temperature resistant silicone rubber spacers instead of typical springs.
With short kit you can use your existing MK1, MK2A or MK2B PCB and upgrade your printer at lower cost.
3-point adjustment is possible with compatible heater and y carriage.
Prusa i3 Y-Carriage Aluminum Plate:
Compatible with various Prusa i3 variations
Great replacement for plywood or acrylic Y-plate - does not warp under the heat
Compatible with 3-point level adjustment option
Compatible with LM8UUs, SCV8UUs and SC8UU linear bearings (SC8UUs are included in this kit).
Silicone Heater Specs:
Voltage: 12V DC or AC
Power rating: 200 Watt or 3.2 Watt per square inch
Length of wiring: 1 meter
Mounting option: 3M sticky adhesive backing
Size: 200 x 200 mm
Thermistor type: NTC 3950, with 1 meter long wiring, supported directly by Marlin firmware
1 x Anodized Aluminum Build Plate 219x219mm.
1 x 12V / 200W Silicone Heater with pre-installed power wires, thermistor and thermistor signal cable.
1 x Anodized Aluminum Y Carriage for Prusa i3
12 x M4x0.7 x 10 Philips Head Screws
2 x M3x0.5 x 12 Philips Head Screws
1 x PLA Printed Belt Holder for GT2 Belt
3 x SC8UU Linear Ball Bearings
4 x M3 x 25 Stainless socket head countersink screws.